Single LED light for use with the Stair Light Controller. All of the parts are included to make a stair light, assembly is required. Included is the super bright white LED, current limiting resistor, small heat shrink to protect resistor from shorting out, large white heat shrink to cover resistor and wire connections, 10 inches of wire to wire as leads and 2 wire connectors.
Once it is constructed installation is easy, simply drill a hole in the stair at the desired location, pop this unit in and connect it to a wire running to the control panel. You will need to purchase one LED light for each step you want to light.
If you want to save time and have your stair lights arrive fully assembled you can also purchase them ready to go. For full assembly instructions take a look at the kit site. Here are a few pictures of the items that make a stair light
From left to right: 10 inches of 4 conductor wire, only 2 conductors will be used (red and black)Super bright white LED, see pictures of the assembled stair light for it's intensity100 ohm current limiting resistorBlack heat shrink to cover the resistor once soldered in placeWhite heat shrink to cover the wire / resistor connectionNot shown are the 2 included wire connectorsAs you can see 10 inches of wire is provided, one end will need to be stripped and soldered to the resistor and LED, the other end will need to be stripped and connected to a wire from the Stair Light Controller .
|