IAR KickStart Kit Plus for NXP (Philips) LPC2378 -02 contains all the necessary hardware and software and allows you to design, develop, integrate and test your applications:
- Olimex LPC2378-STK development board
- 20-state version of visualSTATE
- IAR Embedded Workbench with a 32KB version of the IAR C/C++ Compiler
- IAR J-LINK JTAG debugger with USB connector
- IAR PowerPac for ARM evaluation edition
- Micrium board support
Olimex LPC2378-STK Development board
- MCU LPC2378
- Ethernet 100 Mbit
- 2xRS232 serial port
- 2xCAN drivers and connectors
- SD/MMC card connector
- All LPC2378 port signals available on extension connectors
- Reset circuit with external control of Philips ISP utility via USB-RS232 virtual port
- Jumpers for ISP/RUN mode
- 2 user buttons
- 1 joystick
- JTAG connector
- Trace Mictor connector
- USB connector
- Reset button
- Headphone connector
- MIC connector
- Battery holder
- Colour LCD
IAR J-Link USB-driven JTAG interface for ARM
IAR J-Link is a small ARM JTAG hardware debug probe; it connects via USB to the PC host running Windows. IAR J-Link integrates seamlessly into IAR Embedded Workbench for ARM and is fully plug-and-play compatible:
- Any ARM7/ARM9 core supported, including Thumb mode
- Download speed up to 600 KB/sec *
- DCC speed up to 800 KB/sec *
- Seamless integration into IAR Embedded Workbench
- No power supply required, powered through USB
- Max. JTAG speed 12 MHz
- Automatic core recognition
- Auto speed recognition
- All JTAG signals can be monitored, target voltage can be measured
- Support for multiple devices on scan chain
- Fully plug and play compatible
- 20-pin standard JTAG connector
- Optional adapter for 5V targets available
- USB and 20-pin flat cable included
- Wide target voltage range: 1.2V - 3.3V
* Measured with ARM7 at 50 MHz, 12MHz JTAG speed.
|