The Blackhawk USB2000 JTAG Emulator is a low-cost C2000 DSP emulator and Flash Programming solution. It is based on the Blackhawk USB510, which is the fastest XDS510 class emulator using the high-speed USB 2.0 interface.
Features
- Super Low-Cost XDS510-class Controller
- USB Host Interface
- Bi-Color Status LED (red/green)
- Standard TI 14-pin JTAG Ribbon Cable
- Plug-n-Play Installation
- 3.3/5.0 volt device I/O support
- Variable TCK
- Code Composer Studio v3.3 support
- Support for these TI C2000 High-Performance 32-bit controllers
- F283x, F281x, F280x, F280xx, LF240x
On-chip Flash Programming Supported
- CCStudio C2000 Flash plug-in
- Blackhawk Stand-alone Flashburn Utility
Command-line, Scriptable, Uses TI Flash APIs
An isolation adapter is also available in the Blackhawk Adapters section of this shop, which is recommended for production and test environments, which will help protect the emulator and your PC from ground loops currents.
Target Connector14-pin 0.1in Target HeaderPinSignalPinSignal1 TMS2 nTRST3 TDI4 GND / TDIS5 TVD6 No Pin (Key)7 TDO8 GND9 TCK_RET (TCKR)10 GND11 TCK12 GND13 EMU014 EMU1
If you require support for the new cTI 20-pin header or next-generation 60-pin Trace header (not included), please look in the Blackhawk Adapters section of this shop.
|