- x2 Servos size: 22x6x10mm weight: 2.85g Torque: 0.4Kgcm@4.8V
- x1 Receiver size: 28x8x8mm weight: 3.05g Range: ~150m Channels: 4
- x1 Speed controller: 12x6x4 weight: 1.90g Voltage 7.2-12V @8A
- For use with Futaba, JR, Sanwa, Hitec, Multiplex transmitters
- Includes light gauge wiring, connectors, JST power/motor lead
- Suitable for use with 2-3 cell lithium polymer batteries
- Suitable for use with GWS Naro receiver crystals 35Mhz FM
- Designed for use with indoor RC models of around 5-25ins wingspan
Miniature engineering at its finest - the exquisite metal-cased micro servos purr into smooth action delivering 0.4 of a Kilogram of torque at 4.8V!
Servo speed is a rapid 0.18 seconds per 60 degrees at 4.8v making these servos suitable for indoor aircraft with tiny wingspans through to medium size indoor slow flyer models.
The BEC-equipped speed controller is designed for use with 7.2-12V batteries of conventional and Li-Po type, with autocutoff based on a percentage (72%) of a fully charged battery. Electronic safety arming is built-in to prevent accidental motor starts.
The 3-gram receiver is designed for use with GWS Naro crystals and can be operated using most of the popular makes of available transmitter. When using a 4th servo with the receiver use a Y-harness to connect the battery. Please note that Nuke plugs are very small so be careful to observe correct polarity when connecting.
The set is supplied with two spare servo arms and retaining screws plus two 8cm leads to connect servo to receiver. Two motor noise supression capacitors are included.
|
