Blue Marble® High Performance 2-Cycle Oil:
Blue Marble® 2-Cycle Oil is an ashless, high
detergent, top-quality lubricant that meets the needs of all high performance
2-cycle engines whether air or water cooled as a premix or oil injected. Blue
Marble® 2-Cycle Oil is made from a highly refined mineral oil, which is
inherently biodegradable, and contains our proprietary patented technology.
Blue Marble® formula improves overall engine
performance and reduces friction and smoke.
Meets or exceeds JASO FD, TC-W3® and ISO EGD
specifications.
U.S. Patents: 5310419, 5540788; Patents
Pending.
Usage info:
Recommended for use in 2-cycle engines in fuel
injections or premix: ATVs, motorcycles, outboard motors, personal
watercrafts, scooters, snowmobiles and other 2-cycle engines.
Safe for use in all power valve systems.
Follow engine manufacturer’s mix
recommendation. Upon first use, run at moderate RPMs for first 20 minutes. Run
at normal RPMs.
Technical Data:
(typical properties not to be considered specifications)
Appearance (color) Clear, dark green
Pour Point < -40° F
Flash Point 184° F
Kinematic Viscosity @ 40° C 38.5
Kinematic Viscosity @ 100° C 7.5
Viscosity Index 160
Tips and Tricks:
When Blue Marble® patented technology is introduced to a combustion engine, a
“greening process” occurs as explained in our technology page of our website.
This process begins when the metal is introduced to our technology and ends at
the time of full surface conversion. This window of time varies from engine to
engine depending on the dilution of fuel/oil ratio and the air/fuel-oil ratio.
We have developed a process to speed up the Blue Marble® surface conversion as
outlined below. This technique is optimal for racers and tuners for quick HP
gains while still protecting the engine. Complications may occur if you are not
qualified to perform these technical instructions.
Remove spark plugs.
Bring “one” piston to TDC (verify TDC through
the use of a non-metallic tool such as a pencil).
Pour in specified amount of 2-Cycle Oil
through spark plug hole and let sit for 2 minutes.
Very slowly turn the engine over 5 revolutions
to allow coating of internal parts with Blue Marble® Oil.
Move on to the next piston/pistons and,
one-by-one, perform the same procedure until all pistons are coated.
Let sit for at least 24 to 72 hours.
Repeat steps Four through Six.
Install spark plugs.
Run engine. (increased smoke will be expected
for several minutes)
Recommended treatment.
Damage could occur to engine if more than specified amount is added.
Piston or Bore size in millimeters Amount Added Blue® Marble High Performance
2-Cycle Oil
Under 50mm 1/2 oz.
Between 50mm to 60mm 1 oz.
Between 60mm to 70mm 1 & 1/2 oz.
Between 70mm to 85mm 2 oz.
Between 85mm to 100mm 2 & 1/2 oz.
Over 100mm 3 oz.
|