SPECIFICATIONS - MODEL JR - 250W(For Engine Compartments of 150 cu. ft. or less) (Boats with single engine, up to 24\', or most sailboats)NOTE: This heater WILL NOT provide adequateprotection for a boat that is stored out of the water on a lift, or on a trailer.UNIT DIMENSIONS:51/2H x 41/2W x 141/2 L - 1 Mounting Bracket at each end of unit. Weight - Approximately 4 lbs.UNIT ENCLOSURE:16 Ga. aluminum. Designed for exceptional strength and long life. CAD Vents for proper air flow and maximum heat distribution. Fully Powder Coated for scratch and corrosion resistance.HEATING ELEMENT:250W, Cast Alloy, completely sealed, specially designed and engineered for this application. Cast Alloy provides excellent corrosion resistance. Vibration resistant. Will not spark. UL recognized.THERMOSTAT CONTROL:Hermetically sealed. Factory calibrated and pre-set to activate heater unit when ambient air temperature falls below 45 F (approximately), and continue operation until ambient reaches 55 F (approximately). FM approved.FAN:Heavy Duty, computer style induction fan. Rated at 21 CFM. UL recognized. CSA certified.POWER CORD:15\' - Rated 13A, heavy duty service. Includes a molded 3 prong plug. UL and CSA recognized.UNIT DRAW:Approximately 2.2A at 120V.BTU OUTPUT:860 BTUCOST TO OPERATE:2/Hr. (Based on Average Electricity Cost of 8/KWH)TEST OPERATION OF UNIT:To test the unit when ambient air temperature is above 45oF you must simulate an ambient below 45F. To create the simulation: With the heater unit plugged into a 120V power source, locate the 1/2 dia. hole marked Test on the end cover of the unit. Using the 6 oz. can of Freeze Mist spray supplied with your heater, insert the straw into the nozzle and spray a 2-3 second burst of mist into the Test hole. This will trick the thermostat into turning the heater ON. After a period of time (30 sec. - 3 min.), the ambient temperature of your test environment will resume control of the thermostat and turn your heater OFF.
|
