For years, many have wanted to use water/methanol injection but have not taken advantage of the power increases do to safety concerns. Designed as an ad-on to the Boost Cooler® water/methanol injection system, Safe Injection provides for a safe tune in those instances where no injection is present and an aggressive tune is utilized. This system reduces boost or timing anytime injection quantity goes below a set point (e.g. if reservoir level goes too low) making the tune instantly conservative for the ultimate in safe water/methanol injection.
OperationThe SI-10 and SI-05 monitor the flow of Water/Methanol in the system. When flow drops below 0.10 Gallons per Minute (GPM), equal to 378 ml/min,( 0.05 GPM or175ml/min on the SI-05) the fault trigger will go to a high state of 12 volts. In addition to the supplied red LED, this trigger can be used to signal the following:1. an ignition/timing controller such as an MSD timing computer if using an MSD ignition2. aftermarket engine computer3. a solenoid such that boost is reduced in a wastegated turbo set-up. ( $39.95 list. See below.)4. a solenoid to evacuate boost on a supercharged set-up.The trigger signal can deliver up to 1.5 amps to drive a solenoid or relay.
Part# SI-WS (Wastegate Solenoid Upgrade) $39.95 listPart# SI-SCS (Supercharger Solenoid Upgrade) coming soon.
|