IAR KickStart Kit Standard for NXP (Philips) LPC2129 contains all the necessary hardware and software and allows you to design, develop, integrate and test your applications:
- LPC2129 development board
- 20-state version of visualSTATE
- IAR Embedded Workbench with a 32KB version of the ARM C/C++ compiler
LPC2129 Development board
- MCU: NXP (Philips) LPC2129 16/32 bit ARM7TDMI-S with 256K Bytes Program Flash, 16K Bytes RAM, RTC,4x 10 bit ADC 2.44 uS, 2x CAN, 2x UARTs, I2C, SPI, 2x 32bit TIMERS, 7x CCR, 6x PWM, WDT, 5V tolerant I/O, up to 60MHz operation
- Standard JTAG connector with ARM 2x10 pin layout for programming/debugging with ARM-JTAG
- Three on board voltage regulators 1.8V, 3.3V and 5V with up to 800mA current
- Single power supply: +7-9VDC required
- Power supply status LED
- Power supply filtering capacitor
- Two channel RS232 interface with two RS232 SUB-D 9 pin connectors
- Two channel CAN interface with drivers and two SUB-D 9 pin connectors
- iButton interface circuit
- Frequency input connector
- Two buttons
- Two status LEDs
- Potentiometer connected to AIN
- RESET circuit with exterman control of Philips ISP utility via RS232
- RESET button
- DBG jumper for JTAG enable
- BSL jumper for bootloader enable
- JRST jumper for enable/disable external RESET vontrol by RS232
- 10 Mhz crystal
- Extension headers for all uC ports
- PCB: FR-4, 1.5 mm (0,062in), green soldermask, white silkscreen component print
- Dimensions: 115x80 mm (4.5x3.2in)
Purchase the Plus version instead for JTAG debugging via the J-Link interface (not included in this Standard version)
|